Energy UNITS FOR LIFT TABLE one
Common Description
This power unit is developed exclusively for that small lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become extensively employed in the market of logistic units for example minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled by the solenoid valve with the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Standard Description
This electrical power unit is designed exclusively for your medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as the speed controlled from the adjustable needle valve. When the lift rises to a high positoin, but the energy supply is reduce, the decreasing motion is controlled from the guide override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This power unit is made exclusively for your large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve along with the pace managed by a strain compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is designed solely to the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the speed controlled by the adjustable needle valve. When the lift rises to a high positoin, but the power supply is lower, the lowering movement is controlled by the manual override function.
Specific Notes
1. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic components concerned just before set up of the energy unit.
3. Viscosity of the oil shoud be 15~46 cst,which should also be clean and cost-free of impurities.N46 hydraulic oil is encouraged.
4. Oil modifying is needed soon after the initial one hundred operation hrs,afterwards as soon as each 3000 hours.
five. The energy unit proven is intended to be mounted vertically.