C Variety Flex-Flex Couplings
The C Variety coupling includes two flex hubs, 1 sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Style coupling include one flex hub, a single rigid hub, a single sleeve, a single accessory kit consisting of seals and snap rings.
Characteristics
Very simple and economical type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Readily available as vertical and horizontal couplings
Broad assortment of exclusive variations for example full-flex, flex-rigid mill motor
Typical configurations are available with the shelf
Ordering Facts
Application: Driver and Driven.
Sort and size of coupling, horizontal, vertical and so forth.
Power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Variety Couplings
Ordering Details
Puller Holes are normal on sizes four by twelve.
Puller Holes can be found for sizes 7/8 as a result of three.5 at an extra charge.
The BSE (distance Between Shaft Ends) might vary among G and G1.
Interference bores without any set screws are typical unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek the advice of Engineering Segment.
Greater sizes are available, please consult Technical Assistance.